Communicate with Supplier? Supplier
Doris Ms. Doris
What can I do for you?
Contact Supplier
 Tel:86-0755-81781055 Email:doris@hongfadoor.com
Home > News > How to repair the glass automatic sliding door when it was blown out by the wind?
Online Service
Doris

Ms. Doris

Leave a message
Contact Now

How to repair the glass automatic sliding door when it was blown out by the wind?

2019-04-18
How to repair the Glass Sliding Door when it was blown out by the wind?

Due to the influence of the large typhoon "Mangosteen", there are many supermarkets and shops in the Pearl River Delta region with different degrees of damage to the glass automatic doors. Here are a few of the different parts of the door broken how to repair:

1. The tempered glass is broken. This is the most influential situation in the typhoon. The most common accidents occur. The branches that are broken outside or the trash cans that are not fixed are flying over and smashed. If there is a whole piece of tempering. The glass is broken. The Hongfa automatic door suggests that you can directly purchase the glass replacement. You only need to remove the broken glass from the automatic door clamp and replace it with a new custom glass.

2, the edge or the door column is damaged, the edge is damaged, if it does not affect the safety, but the appearance is damaged, you can use other stickers, such as stickers or decorations, if the door column and other structures that will affect the safety are broken, it must be Look for the manufacturer of the glass automatic door to repair the door to avoid accidents. If the damage is severely damaged, only the entire door can be reinstalled.


Automatic sliding doo


3. The radar sensor is out of order or broken. If it is malfunctioning, it may be externally blown by the wind. It only needs to remove the adjustment angle and check whether the wire is in good contact. If it is completely broken, just buy and replace the hofic 24GHz. The radar sensor probe is fine. Details can be found at http://www.hfzdm.com/product/631.html

4, safety photoelectric failure or broken, failure may be the sensor head is dirty, wipe or adjust it, if it is broken, you need to replace the new safety photoelectric to prevent the door clip hurt. Details can be found at: http://www.hfzdm.com/product/629.html

5, the access control failure, this may be caused by long-term access to the water outside the door, it is recommended to replace, so as to avoid other problems later.

6, the entire door is basically broken, this situation can basically only remove the original glass sliding door, install a new automatic door.

Home

Phone

Skype

Inquiry